TECO T-verter N2 Series - Frequency Limits (Fn_06, Fn_07); Target Speed Detection (Fn_08, Fn

To Next Page

To Previous Page

Fn_05 B C Fn_05 B C Fn_05 B C

0/9 6.5% 6.5% 3/12 9.5% 4.9% 6/15 10.0% 5.1%

1/10 7.5% 6.1% 4/13 20.0% 6.1% 7/16 12.0% 4.7%

215~230

415~430

2/11 8.5% 5.5% 5/14 25.0% 5.8% 8/17 14.0% 4.2%

Fn_06 Upper Frequency Limit

You can adjust the maximum speed of the motor by raising the Upper Frequency limit at (Fn_06)

Fn_07 Lower Frequency Limit

You can set the minimum speed for the motor by adjusting the Lower frequency Limit at (Fn_07)

100%

Internal

Frequency

Signal

Fn_08 At Target Speed 0 ~ 400 Hz

You can close a Multi-function output at terminal at a determined target speed at terminals

(10 & 11), You must assign (Fn_61) to ( 2~4 ) along with determining your target speed at Fn_08

Fn_09 Target Speed Detection 0 ~ 30 Hz

When the Fn_61 set to 2, the terminals 10 & 11 status will follow the output frequency

times

off on off

Note:

Terminals 10 & 11 are normally open during power off, and normally closed during power on.

Fn_06 (Upper Frequency Limit)

Fn_07 (Lower Frequency Limit)

Fn08

Fn09

TECO T-verter N2 Series - Frequency Limits (Fn_06, Fn_07); Target Speed Detection (Fn_08, Fn_09)