42
Fn_37: Maximum Frequency 0.01 Hz = 50 to 400 Hz
Fn_38: Maximum Voltage Ratio 0.1 % = 0 to 100 %
Fn_39: Middle Frequency 0.01 Hz = 0.11 to 400 Hz
Fn_40: Middle Voltage 0.1 % = 0 to 100 %
Fn_41: Minimum Voltage Ratio 0.1 % = 0 to 100 %
In order to build Custom V/Hz Patterns, (Fn_05) must be set at 18.
Fn_42: Starting Frequency = 0.1 - 10 Hz
The T-verter can start at 5 Hz and still have an operational control range of 0.1 ~ 60 Hz. To
accomplish this (Fn_07) will need to be set at 0 Hz, and (Fn_42) at 5 Hz.
Fn_43: Carrier frequency = 1 –12 kHz
Fn_43 Carrier freq. Fn_43 Carrier freq. Fn_43 Carrier freq. Fn_43 Carrier freq.
0 1 kHz 4 2.4 kHz 8 4.8 kHz 12 8 kHz
1 1.2 kHz 5 3 kHz 9 5 kHz 13 9 kHz
2 1.8 kHz 6 3.6 kHz 10 6 kHz 14 10 kHz
3 2 kHz 7 4 kHz 11 7.2 kHz 15 12 kHz
Note:
An IGBT type T-verter can provide a lower audible motor noise using a higher carrier frequency.
However, a drive with to high of a carrier frequency may lead to interference in other electronic
equipment. It’s recommended that a carrier frequency of not more than 10 or 12 kHz be used for
protection of the motor and surrounding equipment that may be sensitive to high carriers.
Voltage
Frequency (Hz)
(Fn_37)
Maximum Fre
uenc
(Fn_39)
Middle Frequency
(Fn_38)
Maximum Voltage
(Fn_40)
Middle Voltage
(Fn_41)
Minimum Voltage
To Next Page
Loading...
