TECSYSTEM NT538 ETH - Default Chapter; Table of Contents

To Next Page

To Previous Page

NT538 ETH

PAGE

1) SAFETY REQUIREMENTS

……….......................................

2) ACCESSORIES

…………………………………..

3) TECHNICAL SPECIFICATIONS

…………………………………..

4) FRONT PANEL

…………………………………..

 DISPLAY

…………………………………..

 OPERATING PROGRAM CONTROL

………………………………….

—

 NOTES ON SCAN AND MAN FUNCTIONS

…………………………………..

—

 LED TEST

…………………………………..

—

 ALARM RELAY TEST

…………………………………..

—

 ALARM RELAY SILENCING

…………………………………..

—

5) MOUNTING

…………………………………..

6) ELECTRICAL CONNECTIONS

…………………………………..

 NT538 ETH BACK

…………………………………..

—

 POWER SUPPLY

…………………………………..

 ALARMS AND VENTILATION

…………………………………..

—

 FAULT AND RESET MESSAGE SEQUENCE

…………………………………..

—

7) PROGRAMMING

…………………………………..

 NT538 ETH

…………………………………..

—

 PROGRAMMING NOTES

…………………………………..

 TEMPERATURE SENSORS

…………………………………..

 MEASUREMENT SIGNAL TRANSFER

…………………………………..

—

 TEMPERATURE SENSOR DIAGNOSTICS

…………………………………..

 VOTING FUNCTION

…………………………………..

—

 PROGRAMMED DATA DIAGNOSTICS

…………………………………..

 TEMPERATURE DIAGNOSTICS

…………………………………..

—

 COOLING FAN CONTROL

…………………………………..

—

 FAN TEST

…………………………………..

—

CONTENTS

INTRODUCTION

First of all we wish to thank you for choosing to use a TECSYSTEM product and recommend you read this instruction

manual carefully: You will understand the use of the equipment and therefore be able to take advantage of all its

functions.

ATTENTION! THIS MANUAL IS VALID AND COMPLETE FOR THE NT538 ETH CONTROL UNIT