98
CAUSE
1) 2) 3)
The remote control
cable is not adjusted
well inside the
appropriate clamp
on the engine control
plate.
4)
The blade is loose.
Be careful of
frictioned bosses,
the blade can slide
due to wearing of
friction washers or
the boss’s autting
end may be worn.
5)
In the case of a self-
moving machine, the
latter does not appear
to be disconnected
properly or makes
resistance.
SYMPTOM
1/1
Engine does not
start or is slow in
starting.
1/2
Engine does not give.
1/3
Engine does not shut
off.
1/4
Engine does not
start or kicks back
1/5
Engine does not
respond and is slow
in starting.
REMEDY
1) 2) 3)
Adjustment of ends
of stroke of control
cable.
4)
Act on boss or by
locking the blade or
replacing used parts.
Check flywheel pin
and replace, if ne-
cessary.
5)
Adjust or act on
traction.
ATTENTION
-
Lift
machine or replace
on already cut grass.
DEFECT
1)
The starter throttle is not completely closed,
therefore, the engine has difficulty in starting
due to lack of fuel enrichment, especially when
cold.
2)
The MAX machine setting does not correspond
to the MAX engine position. The regulator is
not completely connected, therefore, the
engine supplies less power.
3)
The machine’s STOP position does not
correpsond to the engine’s STOP position.
4)
Without the flywheel effect, the engine has
difficulty in starting and sometimes appears to
be out-of.-phase, kicks back and breaks the
flywheel pin easily, which creates additional
difficulty in starting.
5)
The engine must be started from neutral,
therefore disengaged.
If resistance is created by traction in this
position, the engine will be harder to start up.
ATTENTION
-
This effect is also created
when the machine is started up with the blade
makes resistance against the grass.
EQUIPMENT TROUBLE
CHAPTER 1
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
To Next Page