18
ELECTRIC STARTER ASSEMBLY
ATTACH THE GROUND WIRE prior to assembling the
electric starter to the baffle, attach the black ground wire
to the electric starter through bolt so the the wire extends
between the two adjacent end cap prongs (illustration).
Place the starter into the back plate with the ground
wire bolt away from carburetor (see picture). Note that
the throttle linkage is routed around starter while the
governor spring is routed through the end cap prongs
(illustration).
Tighten nuts on starter bolts (see specifications). Place
blower housing on engine and slide wires through slot
making sure not to cut insulation. Press grommet into
hole. Reassemble gas tank, air cleaner assembly and
face plate.
ATTACH GROUND
WIRE
STARTER PRONGS
BATTERY GROUND
LEAD ATTACHED TO
ELECTRIC STARTER
MOTOR STUD BEFORE
ELECTRIC STARTER
MOTOR IS ATTACHED
TO BLOWER HOUSING
BAFFLE
Not For Resale
www.SmallEngineDiscount.com
To Next Page
Loading...
