EasyManua.ls Logo

Tecumseh VLV - CARBURETION; Carburetor Identification; SPLIT System Carburetor; MARRIED System Carburetor

Tecumseh VLV
49 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
CARBURETION
SPLIT
Ref.
No. Part Name
1 Throttle Shaft & Lever Assy.
5 Dust Seal (Throttle)
6 Throttle Shutter
7 Throttle Shutter Screw
25 Float Bowl
25A Idle Restrictor
26 Float
27 Shaft, Float
29 Gasket, Float Bowl to Body
30 Inlet Needle, Seat & Seat Retainer (Incl. 31)
31 Seat Retainer
32 Bowl Drain Assy.
36 Tube, Main Nozzle
37 O Ring, Main Nozzle Tube
38 Spring, Main Nozzle Tube
39 Float Bowl Retainer
47 Welch Plug, Idle Mixture Well
*
MARRIED
39
32
33
38A
40
37A
25
25A
38
37
36
26
30
27
*
Ref.
No. Part Name
1 Throttle Shaft & Lever Assy.
5 Dust Seal
6 Throttle Shutter
7 Throttle Shutter Screw
25 Float Bowl
25A Idle Restrictor
26 Float
27 Float Shaft
29 Gasket, Float Bowl to Body
30 Inlet Needle, Seat & Seat Retainer (Incl. 31)
31 Seat Retainer
32 Bowl Drain Screw
33 Bowl Drain Washer
36 Tube, Main Nozzle
37 O Ring, Main Nozzle Tube
37A O Ring
38 Spring, Main Nozzle Tube
38A Spring
39 Float Bowl Retainer
40 Main Fuel Jet
47 Welch Plug, Idle Mixture Well
39
32
25
25A
38
37
36
29
47
26
30
27
1
5
7
6
*
6
7
5
1
47
29
*
*
31
*
31
*
*
Proper Carburetion Function is dependent on clean fresh
fuel and a well maintained air cleaner system. Most
causes of carburetion problems are directly related to
stale fuel and dirt ingestion. Inspection of the carburetor
for dirt wear and fuel deposits should always be done
before servicing the carburetor.
Carburetor Identification:
Tecumseh carburetors are identified by a manufacturing
number and date code stamped on the carburetor as
shown. When servicing carburetors, use the engine
model number or the manufacturing number on the
carburetor to find repair parts in the Master Parts Manual.
The engine has used both a split system and married
system carburetor. Below are the parts breakdowns for
the two carburetor's.
TORX E-5
STUD
NOTE: LATER MODEL VECTOR CARBURETOR BODIES ARE
HELD ON WITH TORX E-5 STUDS. YOU WILL NEED THIS
SOCKET FOR REMOVAL. TECUMSEH PART NO. 670339.
NOTE: The seat retainer may not be present on some engines. If you receive a retainer as a service part, install it.
*
MANUFACTURING NUMBER
AND DATE CODE
Not For Resale
www.SmallEngineDiscount.com

Table of Contents

Related product manuals