7
ASSEMBLY
Step Four
Attach the Table Bed
(EP-1140) to the
A-frame (EP-1100)
• Holding each side near the
Roller Hinges, pick up the
Table Bed and stand at the
front of the A-frame where
the Crossbar is located. Lower
each Pivot Pin into the A-frame
hinge plates one at a time
(Figure 7). You may need to
push outward on the A-frame
in order to slide the second
Pivot Pin into the hinge. Figure
9 shows the correct placement
of the Pivot Pin into the hinge
plate.
• Make sure that both Pivot Pins
are seated at the base of the
slot in the hinge plate. Check
to make sure that the self-
locking hooks have closed over
both Pivot Pins (Figure 9), and
the table rotates smoothly.
WARNING
!
Failure of the self-locking hooks to close over both Pivot Pins is indication of
improper assembly and if not corrected, could result in serious injury or death!
Figure 9
Figure 7
Teeter Hang Ups EP-950
Figure 8
To Next Page
Loading...
