EasyManua.ls Logo

Teeter FitSpine Trainer User Manual

Teeter FitSpine Trainer
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INVERTING
When correctly balanced, the inversion table will rotate in response to simple arm
movements. To invert, lift your arms overhead slowly and to return upright, bring your arms
back to your sides. Your arms provide the weight needed to rotate the table. (Figure 9).
To ensure the table does not rotate too far, too quickly:
1. Set the Roller Hinges to Setting “C” (as explained on pg. 2);
2. Attach the Nylon Tether to the underside of the Table Bed and test to max rotation;
3. Raise one arm at a time, and do so very slowly (the faster you move, the faster the
inversion table will rotate).
To use the traction bars on the Support Handles, push against them while inverted to achieve a
greater decompression and relaxation.
RETURNING UPRIGHT
• To return to the upright position, put your arms at your sides (Figure 10). Since your
body may have lengthened or shifted on the Table Bed during inversion, you may need
to bend your knees to shift your body weight to the foot side of the pivot point.
DO NOT lift your head or try to sit up.
FULL INVERSION
Denition: Hanging completely upside down by your ankles with your back free from the table.
DO NOT
attempt this step until you are comfortable with partial inversion.
• Disconnect the nylon tether.
• Set the Roller Hinges in the top hole setting “A” if you want the table to “lock” rmly while
inverted. If you are 220 lbs (100 kg) or more, set the roller hinges in the “B” hole setting.
• From a balanced position on the table, slowly raise both hands over your head to begin
rotation. You may need to assist the last few degrees of rotation by pushing on the oor
or A-frame until the table pulls away from your back. In your correct balance setting,
your weight will keep the table “locked” in this position until you are ready to return
upright (Figure 11).
To Release from the Inverted “Locked” Position:
• Reach one hand over your shoulder and grip the corner of the Table Bed.
• Place the other hand on the bottom bar of the A-frame in front of you (Figure 12).
• Pull both hands together. This will rotate the table out of the “locked” position. Slowly
move your arms and elbows to your sides to complete the rotation.
USE CAUTION: Elbows protruding over the sides of the Table Bed could get pinched
between the A-frame and the Table Bed as you return upright.(Figure 13).
It is your responsibility to familiarize yourself with the proper use of the equipment and the inherent
risks of inversion, such as falling on your head or neck, pinching, entrapment or equipment failure.
DO NOT use the inversion table until you have thoroughly and carefully read the Owner’s Manual,
reviewed all accompanying documents and inspected the equipment. ALWAYS test and inspect the
equipment for smooth operation prior to each use.
WARNING
!
INVERT
Owner’s Manual
For information about the 1-year warranty,
or if you have any problems assembling the equipment,
or questions about its use, please contact customer service at:
STL International, Inc.
9902 162
nd
St. Ct. E., Puyallup, WA 98375
Toll Free (Phone) 800-847-0143 (Fax) 800-847-0188
Local (Phone) 253-840-5252 (Fax) 253-840-5757
(e-mail) info@FitSpine-System.com (web) www.FitSpine-System.com
U.S. patents apply.
FitSpine™ is a registered trademark of STL International, Inc.
Specications subject to change without notice.
© COPYRIGHT 2010, STL International, Inc.
International Law Prohibits Any Copying, 0510-2 LS-2000
Max User Height: 6 ft 6 in (198 cm)
Max User Weight: 300 lbs (136 kg)
FAILURE TO FOLLOW INSTRUCTIONS AND WARNINGS COULD RESULT IN SERIOUS INJURY OR DEATH.
WARNING - To reduce the risk of injury to persons:
• Read and understand all the instructions, view the instructional video, review all other accompanying documents, and inspect the
equipment before using the inversion table. It is your responsibility to familiarize yourself with the proper use of this equipment and the
inherent risks of inversion, such as falling on your head or neck, pinching, entrapment, or equipment failure. It is the responsibility of the
owner to ensure that all users of the product are fully informed about the proper use of the equipment and all safety precautions.
• Close supervision is necessary when the inversion table is used near children, or by or near invalids or disabled persons.
• Use the inversion table only for its intended use as described in this manual. DO NOT use attachments not recommended by
the manufacturer.
NEVER drop or insert any object into any opening.
DO NOT use or store product outdoors.
DO NOT use if you are over 6 ft 6 in (198 cm) or over 300 lbs. (136 kg). Structural failure could occur or head/neck may impact
the oor during inversion.
DO NOT allow children to use this machine.
• Keep children, bystanders, and pets away from machine while in use.
• Keep body parts, hair, loose clothing and jewelry clear of all moving parts.
• The inversion table has no user serviceable parts.
This product is intended for home use only.
DO NOT use in any commercial, rental or institutional setting.
DO NOT operate equipment while under the inuence of drugs, alcohol, or medication that may cause drowsiness or disorientation.
ALWAYS inspect the equipment prior to use. Make sure all fasteners are secure.
ALWAYS replace defective components immediately and/or keep the equipment out of use until repair.
ALWAYS position equipment on a level surface and away from water or ledges that could lead to accidental immersion or falls.
ALWAYS wear securely tied lace-up shoes with a at sole, such as a normal tennis style shoe. DO NOT wear any footwear that could
interfere with securing the ankle clamps, such as shoes with thick soles, boots, high-tops or any shoe that extends above the anklebone.
ALWAYS make sure the equipment is properly adjusted to the correct user settings prior to each use.
DO NOT use aggressive movements, or use weights, elastic bands or any other exercise or stretching device while on the inversion
table.
New users, and users who are physically or mentally compromised, will require the assistance of a partner to ensure they are able to
nd the correct balance setting and can return to an upright position unassisted.
If you feel pain or become light-headed or dizzy while inverting, immediately return to the upright position for recovery and eventual
dismount.
DO NOT use the equipment without a licensed physician’s approval. Carefully review the following list of medical contraindications for
inversion with your licensed physician: (This is not an exhaustive list, it is intended only for reference)
· Middle ear infection · Glaucoma · Heart or circulatory disorders · Bone weakness (osteoporosis)
· Extreme obesity · Retinal detachment · Spinal injury · Recent or unhealed fractures
· Pregnancy · Conjunctivitis · Cerebral sclerosis · Medullary pins
· Hiatal hernia · High blood pressure · Acutely swollen joints · Surgically implanted orthopedic supports
· Ventral hernia · Hypertension · Recent stroke or transient · Use of anticoagulants
ischemic attack (including high doses of aspirin)
Refer to additional warning notices posted on the equipment. If a product label or Owner’s Manual should become lost, damaged or
illegible, contact Customer Service for replacement.
WARNING
!
Figure 9
Figure 10
Figure 11
Traction
Bars
Figure 12
Figure 13
To reduce tipping hazard, conne all inverted activities to smooth movements.
Aggressive exercises that involve vigorous body movement can cause the
table to tip over, resulting in serious injury or death!
WARNING
!
Question and Answer IconNeed help?

Do you have a question about the Teeter FitSpine Trainer and is the answer not in the manual?

Teeter FitSpine Trainer Specifications

General IconGeneral
TypeInversion Table
Weight Capacity300 lbs
Height Capacity4 ft 8 in - 6 ft 6 in (142 - 198 cm)
MaterialSteel frame
Inversion Angle Range20-90 degrees

Summary

Invert Operation

Invert Process

Instructions on how to rotate the inversion table using simple arm movements for inversion.

Returning Upright

Steps to safely return to the upright position after inversion, including body weight adjustments.

Full Inversion Definition

Defines full inversion as hanging completely upside down and advises caution for beginners.

Finding Your Settings

Roller Hinge Adjustment

Guidance on adjusting roller hinges based on body weight for desired rotation responsiveness.

Height Setting Adjustment

Instructions for adjusting the main shaft height based on user height for safe operation.

Nylon Tether Attachment

Advice on attaching the nylon tether to control rotation angle, especially for new users.

Foot Platform Adjustment

How to adjust the foot platform for optimal ankle clamp fit, reducing body slide during inversion.

Secure Your Ankles

Detailed steps and warnings for securely fastening the ankle clamps before using the inversion table.

Test Your Balance

Procedure to test and find the correct balance setting for smooth rotation and safe return.

Related product manuals