TEFAL CLIPSO - Re-fitting the Control Module and Seal

11
20
Re-fitting the control module
(See chapter on control module)
Re-fitting the seal
■ For better visibility, this operation must be
carried out with the lid in the open position, i.e.:
with the jaws open.
■ To ensure a perfect seal, make sure the seal slips
fully under each tab by pressing and pushing it with
your finger towards the edge of the lid.
Change the lid seal once a year.
Have your pressure cooked checked at a
TEFAL Approved Service Centre after 10 years of
use.
Storing your pressure cooker
■ Turn the lid upside down on the pot and adjust so
that it rests in a stable position, ensuring that it is at
an angle so that one side sticks out slightly (see
diagram opposite).
!
!
Cleaning and Maintenance
4132081 CLIPSO CONTROL UK 18/09/02 10:36 Page 20