1313
Comments
21-22-23
If you want to cook food to different
personal tastes, open the grill and remove the
food when it has reached the desired level
and then close the grill and continue cooking
the other food. The program will continue its
cooking cycle until it reaches the ‘well done’
level.
24 Keep warm function
When the cooking process has ended the
appliance will automatically go on the keep
warm setting after having reached the “well
done” level. If food is left on the grill it will
continue to cook, while the cooking plates
are cooling.
Comment:
the safety system will turn the
appliance off automatically after a certain
amount of time.
Second cooking
If you want to cook more food, please refer
to p.14.
21 22
23 24
Cooking more food
If you want to cook a second batch of food, please pre-heat the appliance again (starting from point 9 in automatic
mode or point 25) even if you want to cook the same type of food.
How to cook another batch of food:
After finishing your first batch of food:
1. Make sure the appliance is closed with no food inside.
2. Select the appropriate cooking mode/program (this step is necessary even if you decide to pick the same cooking
mode than for the previous batch of food).
3. Press “OK” to start preheating. During this phase, the temperature indicator (in MANUAL mode) or the PREHEAT
indicator (in automatic mode) will blink. This stage is mandatory even if your appliance seems hot.
4. The pre-heating is complete when an audible beep is heard and the cooking level indicator stops flashing.
5. After the pre-heating, the appliance is ready for use. Open the grill and place the food inside the appliance.
Important:
– Please note that any new batch of food, the pre-heating phase is mandatory.
Remember to always have the grill closed and no food inside in order for the preheating to effectively
function.
– Then wait for the pre-heating to be complete before opening the grill and place the food inside.
N.B.:
if the new pre-heating cycle is carried out immediately after the end of the preceding cycle, the
pre-heating time will be reduced.
To Next Page
Loading...
Need help?
General