Tefcold NOC60CC-P - Check before You Call a Service

1
CHECK BEFORE YOU CALL A SERVICE…
Possible failure Possible cause Solution
The device does
not turn on
Power cord is disconnected.
Connect the power cord.
Power cord is damaged. Call electric service.
Main switch is turned off.
Turn on the main switch (check the fuse).
Too high
temperature
in display
or exposition
Ambient conditions not in accordance
with the instructions
–
device exposed to sunlight
– drafts (wind)
– air conditioning disturbs
the air circulation in the device.
Change the device location
and ambient conditions
to the guidelines in the instructions.
Dirty condenser. Clean the condenser.
Furniture installation of the device
does not comply with the guidelines.
Increase the area hot air inlets / outlets
from the condenser.
Check the air temperature
in front of the condenser.
Iced evaporator.
Turn on additional defrost
(see instructions).
Loading level exceeded.
Change loading according
to the level indicators.
Condensation
on the windows
/ glasses
Ambient conditions not in accordance
with the instructions.
Ensure proper operating conditions
(see instructions).
Bad air circulation.
Ensure proper air circulation.
Remove the obstacles on the intake
and air outlet.
Water on the floor
PTC heater failure.
Call service.
Ambient conditions not in accordance
with the instructions.
Ensure proper operating conditions
(see instructions).
A sudden
appearance of steam
or condensation
on the interior
parts of the glass
Defrost process was initiated
automatically or manually.
After the defrost process, the steam,
condensation will disappear.
The sound
of cracking,
clicking
Defrost process was initiated
automatically or manually.
During the defrost process
there appear stresses resulting
from temperature differences.
At the end of the process,
the sounds will disappear.