Fig. 7 Fig. 8
4. CONDITIONS FOR SAFETY AND WORKING HYGIENE
1.
Do not connect the device to the electrical network until protective devices have been installed.
2.
Installation of the electrical installation should be made by a qualified electrician.
3.
All repairs and adjustments in the electrical system may only be carried out by an authorized
electrician. In the event of malfunctions such as: power punctures, sparking, etc., the device should
be immediately disconnected from the power supply and an electrician should be called in to
remedy the fault.
4.
Wash and clean the device only after disconnecting from the power supply.
5.
If the power cord is damaged, it should be replaced by the manufacturer or by a specialist repair
facility or by a qualified person in order to avoid a hazard
6.
In the event of refrigerant leakage, avoid using open flames or sources of ignition near the leak.
7.
Repairs in the refrigeration system may only be performed by trained technical personnel
authorized to work with flammable agents (R290).
5. WARANTY REPAIRS
1.
The user, when purchasing the device, receives a warranty card with the serial number and the
date of production of the product. This data should be in accordance with the data on the
device’s rating plate
2.
If the device is purchased from a wholesaler distributing JUKA’s products, the Warranty Card
that does not have the date of purchase and the Seller’s stamp will not be honored.
3.
The warranty repairs are performed by the manufacturer or the nearest authorized plant
performing service services
The warranty period is extended by the duration of the repair
To Next Page
Loading...
