2.7.
Individual decoration panel building of devices
The manufacturer allows the individual housing (installation) of the device provided that:
•
Ensure proper air circulation in the device;.
•
Do not install, cover the rear of the condenser and the control panel.
•
Ensure free access and the possibility of removing the rear grille for periodic cleaning of the
condenser.
•
Ensure that the compressor can be serviced, for this purpose the possible „front” installation should
be disassembled in order to ensure free access to the refrigeration system components. Ensure
the possibility of pulling the entire device out of the body.
•
In the case of the installation of the front grille, ensure the air flow through appropriate
openings, air ducts, whose position and surface should be located parallel to the existing openings
in the device. The area of holes in a new building cannot be smaller than the area of existing holes.
EXACT GUIDELINES FOR INSTALLATION OF INDIVIDUAL
DECORATIONS IN DEVICES
–
CONTACT WITH THE MANUFACTURER.
2.8.
Transport
The device in transport requires careful protection against the effects of shocks, as well as accidental
overturning. Glass elements and varnished coatings are particularly vulnerable.
The device should be in a horizontal position both during transport and transfer or removing time.
If the device must be tilted:
1.
Disassemble the glass in a specific order and secure the connecting elements against loss,
2.
After installing and setting the device in a specific place, reassemble the glass in reverse order.
The connection to the mains should be made after a minimum of 6 hours to allow draining the
compressor oil.
3.
MAINTENANCE
1.
The current maintenance of the device is carried out by the user on their own through periodic
cleaning of the body, display part, glass, etc.
2.
Washing should be done after disconnecting the device from the mains, using warm water without
detergent. Use anti-static materials for cleaning
3.
Window cleaning:
Do not leave the device with open front window unattended.
To Next Page
Loading...
