WORK ONLY IF THE ENGINES ARE OUTSIDE OR IN A WELL VENTILATED POINT. THE EXHAUST GAS OF
THE ENGINES IS ODOURLESS AND ITS INHALATION CAN CAUSE SERIOUS OR FATAL ACCIDENTS.
THE CONTACT WITH ELECTRIC ENERGIZED LINES CAN BE FATAL
• Pay the maximum attention when you cut, demolish, drill, etc. near energized electric lines that can
be buried, walled or hidden.
• Be very careful also to gas and water pipes, telephone lines or other buried cables or ducts.
• The working area must be free from objects that may fall, get spoiled, catch fire, make trip up or make
the operation difficult or dangerous.
• Warn and move away imprudent bystanders or other people not authorized or involved with the job.
• If you work in narrow or closed rooms always plan a way out that must be kept free.
• Before using the equipment make sure and prevent vehicles, machines or people from passing on the
equipment hoses or cables.
• Always connect tools to the power pack or other power sources before starting the engine.
• Keep in a safe dry place this manual and its enclosures, so they can be always available for future
consultations.
THE "MAXIMUM PRESSURE" AND "CUT-OFF" VALVES POSITIONED ON THE SIDE OF THE UNIT
HAVE BEEN ADJUSTED BY TEHMA TO THE MAXIMUM WORKING PRESSURE THAT CAN BE
ACCEPTED BY ITS TOOLS.
MODIFYING THE CALIBRATION OF THESE VALVES CAN POSE SERIOUS RISKS FOR THE
OPERATOR AND THE HYDRAULIC EQUIPMENT, THEREFORE IT IS ADVISABLE TO PROCEED
WITH THIS INTERVENTION ONLY WHEN STRICTLY NECESSARY AND AFTER HAVING
ASCERTAINED THE PRESSURE LIMITS DECLARED BY THE MANUFACTURERS OF THE TOOLS
TO BE CONNECTED TO THE UNIT.
TEHMA IS NOT RESPONSIBLE FOR ANY DAMAGES RESULTING FROM THE VARIATION OF THE
OIL PRESSURE SUPPLIED BY THE UNIT, AS WELL AS FROM THE IMPROPER USE OF THE
EQUIPMENT OR OTHER MODIFICATIONS MADE TO ITS PRODUCTS.
To Next Page
Loading...