For information about the handling and disposal of the dangerous wastes contact the Environment
department of your local municipality.
At the end of their life, all components of the machine must be separated and disposed of in compliance
with the laws in force in your country.
Except for the liquids and materials of the previous list, the other components of the products
manufactured by TEHMA are fabricated with recyclable materials that can be stored, disposed and
scrapped without particular cautions.
MATERIALS AND COMPONENTS USED BY TEHMA DO NOT CONTAIN ASBESTOS OR OTHER
TOXIC ELEMENTS THAT REQUIRE SPECIAL CAUTION FOR THEIR USE.
REPAIR
THE TEHMA HYDRAULIC TOOLS ARE PROFESSIONAL PRODUCTS THAT SHOULD BE REPAIRED
ONLY BY QUALIFIED PERSONNEL.
THE REPAIR MAY REQUIRE TECHNICAL LITERATURE AND INSTRUMENTS FOR THE CONTROL OF THE
HYDRAULIC VALUES AND AN ADEQUATE HYDRAULIC SOURCE NECESSARY FOR CARRYING OUT THE
TOOL FUNCTIONING TESTS. IT IS THEREFORE ADVISABLE NOT TO START THE COMPLETE
DISASSEMBLY OF THE PRODUCT IF YOU ARE NOT A TECHNICIAN AND PROFESSIONAL TOOLS AND
EQUIPMENT ARE NOT AVAILABLE
REPARATION OF PRODUCTS UNDER WARRANTY
IF THE TOOL IS STILL UNDER WARRANTY THE REPAIRS MUST BE CARRIED OUT ONLY BY TEHMA
AUTHORIZED SERVICE AGENTS OTHERWISE THE WARRANTY WILL BE AUTOMATICALLY NULLIFIED.
GENERAL INFORMATION
Although we recommend that the repairs have to be carried out only by authorized TEHMA service
agents, some minor repairs can be carried out also by other engineers, in this case follow these
instructions:
BEFORE DISASSEMBLY
• Clean accurately the product and remove any trace of dirt.
• Keep available a clean working surface, paper, rags, tools, an air gun, a rubber hammer, a brass
punch, a vice with soft protection for the jaws, a clean container for collecting the tool oil.
• Keep available an exploded view of the tool and part list.
• Consider that when the tool is completely disassembled, it’s recommended to replace all exposed
seals.
To Next Page
Loading...