PERIODIC CONTROLS AND SUBSTITUTION OF WORN PARTS
• EVERY TIME THE EQUIPMENT IS USED:
1. Control the hydraulic oil level
2. Control the level of the engine oil (or make the proper maintenance as specified in the manual
of the engine manufacturer).
3. Control the condition of the hoses and quick couplers
4. Carry out a general control of the equipment.
5. Clean carefully the equipment
THE ENGINE OIL SHOULD BE COMPLETELY CHANGED AFTER THE FIRST 5 HOURS OF WORK AND THEN
AS INDICATED IN THE MOTOR MANUFACTURER’S MANUAL
• EVERY 150 HOURS OF WORK – ABOUT EVERY 3 MONTHS:
1. Carry out all the controls of the previous paragraphs.
2. Control that all screws, fastenings and fittings are perfectly locked.
3. Control the state of the hydraulic oil that should to be transparent and without foams. If
necessary, replace completely the hydraulic oil, changing also the used oil that remains inside
the flexible hoses and in the tool.
4. Carry out a complete cleaning of the equipment.
5. Check and blow the engine air filter with compressed air, if it is necessary
6. Clean the equipment carefully.
• EVERY 300 HOURS OF WORK – ABOUT EVERY SIX MONTHS:
1. Replace completely the hydraulic oil, changing also the used oil that remains inside the
flexible hoses and in the tool.
2. Replace the hydraulic oil filter cartridge.
3. Change the engine oil as specified in the manual of the engine manufacturer.
4. Replace the engine air filter.
5. Carry out all the other engine controls as specified in the manual of the engine manufacturer.
6. Check the tightening of bolts and nuts and fittings
7. Check the condition of the flexible hose and hydraulic oil cooler
8. Clean the spark plug
9. Clean the equipment carefully.
MORE ACCURATE INFORMATION ABOUT THE MAINTENANCE OF THE ENGINE ARE EQUIPPED WITH THE
MANUFACTURER’S MANUAL ENCLOSED TO THIS MANUAL.
To Next Page
Loading...