TEHMA PP700-E - Problem Solving and Troubleshooting; Troubleshooting: Engine Not Starting; Troubleshooting: Reduced Tool Performance

23
PROBLEM / CAUSE / SOLUTION CHART
The following table is a guide for finding and solving the most common working problems. The causes of
malfunction often depend on inadequate values of the hydraulic circuit. The control of the PRESSURE-
must be done with oil at a temperature of about 40° C.
PROBLEM:
THE ENGINE DOES NOT START
CAUSE
SOLUTION
Engine switch is in OFF
Bring on ON
Central distribution lever in working
position
Put lever in OFF CENTRAL position
Fuel tap on OFF
(PP600 – S)
Bring on ON
No fuel
Low engine oil level
Add fuel
Add oil engine
Low engine oil level
(PP600 – S)
Add oil engine
If the problem persists, contact the authorized dealer or TEHMA
PROBLEM:
THE HYDRAULIC TOOL HAS POOR PERFORMANCES
CAUSE
SOLUTION
Damaged tool
Check and/or repair the tool