Check the oil level and refill it
NOTE
With the tool SP400/SP600 connected,
make sure to carry out this operation after
completely retracting the central wedge.
Improper circulation of the oil
Control that oil pressure can reach well the
tool – control couplers proper connection -
Check the quick couplers
Oil filter too dirty
No oil in the tank
Substitute the hydraulic oil filter
Control and refill
Check/substitute the quick couplers
Check the oil level
Substitute with oil suitable to the season
If the problem persists, contact the authorized dealer or TEHMA
PROBLEM:
THE TOOL OVERHEATS QUICKLY
Tool operation too frequent and too long
operations
Take breaks to allow the oil to cool down.
If the problem persists, contact the authorized dealer or TEHMA
To Next Page
Loading...