7.8. Replacing the filter mats at the control cabinet
This section is only relevant if the unit is equipped with a control cabinet and this is itself
equipped with a filter fan and an exhaust filter.
There is a filter mat located in the louvred grille on both the filter fan and the exhaust filter. The filter
mats must be checked regularly and replaced if necessary. This check depends on the level of
contamination. We recommend acquiring a stock of filter mats at an early stage (see spare parts list).
● The procedure described here must be performed at both the filter fan and the exhaust filter.
● Pull the logo in the louvred grille upwards a little using your finger. Then fold the louvred grille
downwards.
● Replace the old filter mat with a new one. The blue side must face outwards.
Only use TEKA spare filters. Otherwise the proper functioning of the unit is
not guaranteed.
● Close the louvred grille until it audibly clicks into place.
BA_FilterCube_4_IFA_20230808_EN
To Next Page
Loading...
