Basic settings
Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock is set and
the water hardness parameter is set.
To set the clock and the water hardness
parameter value proceed as described in the
following chapters.
Setting the clock
To set the clock, proceed as follows:
1. Press the OK key (5). The hour numbers will
start to flash (not necessary if your oven is first
plugged in or after a power failure).
2. Press the “+” and “-“ keys (4/6) to set the
correct hour value.
3. Press again the OK key (5) to set the minutes.
The minute numbers will start to flash.
4. Press the “+” and “-“ keys (4/6) to set the
correct minute value.
5. To finish, press the OK (5) key again.
Hiding/Displaying the Clock
If the clock display disturbs you, you can hide it by
pressing the OK key (5) for 5 seconds. The dots
that separate the hours and minutes will flash but
the rest of the clock display will be hidden.
If you want to see the clock display again, press
the OK key (5) again for 5 seconds.
To Next Page
Loading...
