29
Installation & Maintenance
English
SAFETY INSTRUCTIONS
Read these instructions carefully to obtain the best perfor-
mance from your oven, safely and correctly. Keep this manual
so that it can be read by a new owner.
Electrical safety
• If the power cable is not supplied with the oven, the follow-
ing cables may be used in non-pyrolytic ovens: H05RR-F /
H05VV-F / H05V2V2-F / H07RN-F / H05SS-F. In pyrolytic ov-
ens, only the H05SS-F-type cable may be used. The connec-
tion diagram is shown in Figure 1.
• The oven must always be plugged into a sound earth connec-
tion and its installation must comply with current regulations.
• This appliance is intended for use at a maximum altitude of
2,000 m.
• When installing the oven, total disconnection means must
be incorporated into the fixed installation in accordance
with the installation regulations (adapted to the current to
be supported and with a minimum space between the con-
tacts of 3 mm) based on surge protection category III con-
ditions, for disconnection in the event of an emergency and
when cleaning or changing the bulb. Under no circumstanc-
es must the earth wire pass through this switch.
• This switch may be replaced by a plug, provided it is acces-
sible for normal use.
• Any handling or repair to the appliance, including replace-
ment of the power cable, should be carried out by author-
ised Technical Service Personnel using original spare parts.
Repairs or handling by others may damage the appliance or
cause malfunctioning that could be hazardous to your safety.
• Unplug your oven if it malfunctions.
To Next Page
Loading...
Need help?
General
