39
Installation & Maintenance
English
The oven stops working
• Check the power connection.
• Check the fuses and the circuit breaker of
your installation.
• Make sure the timer is either in the manual
or programmed setting.
• Check the position of the control and tem-
perature dial.
The inside light does not go on
• Change the bulb.
• Check it has been properly installed as set
out in the Installation Instructions.
The heating pilot light does not turn on
• Select a temperature.
• Select a setting.
• It should only come on while the oven is
heating up to the selected temperature.
Oven smoking during use
• Normal during first use.
• Clean the oven regularly.
• Reduce the amount of fat or oil in the tray.
• Do not cook at temperatures higher than
those indicated in the cooking chart.
The expected cooking results are not
achieved
• Check the cooking charts for guidance on
how your oven operates.
My accessories and shelf supports are
damaged
• You did not removed the accessories and
supports during the pyrolytic cleaning cy-
cle.
• You must replace them and remove them
during subsequent cleaning cycles.
The enamel colour has changed or stains
have appeared
• The chemical composition of some food-
stuffs may cause changes in the enamel.
• This is normal and does not damage the
properties of the enamel.
The oven is off, the symbol
lights up
and the door will not open
• The door lock is activated.
• Deactivate the door lock following the in-
structions in the User’s guide supplied with
this manual.
The oven is on, the symbol
lights up
but the door will not open
• The door lock is activated.
• Turn the control dial to position
.
Trouble shooting
This section describes some of the most fre-
quent problems that can affect your oven,
along with the most common causes and pos-
sible solutions.
To Next Page
Loading...
Need help?
General
