Teknatool nova PRO-TEK SUPERNOVA2 - PRO-TEK SUPERNOVA2 Chuck Maintenance

33
3.
Tighten the jaw segments while clamping
on the cylindrical bar.
PRO TEK SUPERNOVA
2
Chuck Maintenance
This section introduces the procedures on how to assemble and disassemble the PRO-
TEK SUPERNOVA
2
chuck for maintenance. Regular maintenance is essential to ensure
maximum performance for any mechanical devices including the PRO-TEK
SUPERNOVA
2
chuck.
Attempt to clean and lubricate the chuck components as the first step if the chuck
feels / has become stiff to operate.
Required tools
1. 1 ½” Spanner
2. Circlip pliers (External)
3. 3mm Hex key
4. Flat head screw drivers (x2)
5. Plastic hammer (or block of wood)
6. Multi-purpose grease (Ideally a heavily viscous type)
7. Long piece of timber which can be fitted between the jaws when opened