Tektronix 5 Series

Preface
This document helps customers with data security concerns to clear or sanitize a 5 Series MSO Low Profile MSO58LP
instrument that has factory option 5-SEC installed.
The instrument has data storage devices (memory and a removable mass storage drive) and data export interfaces (USB and
Ethernet). These instructions describe how to clear or sanitize the memory devices and disable the data output interfaces.
The instructions also describe how to sanitize an instrument that is not functioning.
Reference
The procedures in this document are written to meet the requirements specified in:
National Industrial Security Program Operating Manual (NISPOM), DoD 5220.22–M, Chapter 8
Defense Security Service Manual for the Certification and Accreditation of Classified Systems under the NISPOM
Supported products
These instructions cover the following instrument:
MSO58LP with factory installed option 5-SEC
NOTE.
Option 5-SEC must be ordered at the same time that you order an instrument.
MSO58LP with Option 5-SEC Declassification and Security Instructions iii