13. Push the ↓ arrow side-bezel button to position the cursor on the DNS IP
Address field.
14. Enter the relevant field data using the lower bezel buttons and Multipurpose
a knob.
15. Push the OK Accept side-bezel button.
16. Push the Ethernet and LXI lower-bezel button.
17. Push the –more- 1 of 2 side bezel button to get to the second page of side
bezel menus.
18. Push the Change Names side-bezel button.
19. Push the ↑ or ↓ arrow side-bezel button to position the cursor on the
Hostname field.
20. Enter the relevant field data using the lower bezel buttons and Multipurpose
a knob.
21. Push the ↓ arrow side-bezel button to position the cursor on the Domain
Name field.
22. Enter the relevant field data using the lower bezel buttons and Multipurpose
a knob.
23. Push the ↓ arrow side-bezel button to position the cursor on the Service
Name field.
24. Enter the relevant field data using the lower bezel buttons and Multipurpose
a knob.
25. Push the OK Accept side-bezel button.
26. Push the Change e*Scope and LXI Password side-bezel button.
27. Enter the relevant field data using the lower bezel buttons and Multipurpose
a knob.
28. Push the OK Accept side-bezel button.
Clear and sanitize procedures
MDO3000 Series Declassification and Security Instructions 11
To Next Page
Loading...
