Acquire the Signal
2. Push Trigger Menu an d enter trigger
parameters. (See page 129, Choosing a
Trigger Type.)
You can display bus information without
triggering on the bus signal.
SettingUpBusParameters
NOTE. For all serial bus sources, use any comb ination of channels 1 through 4, and D15 through D0.
To trigger on serial or parallel bus conditions, refer to Triggering on B uses. (See page 135, Triggering on Buses.)
DPO2000 and MSO2000 Series Oscilloscopes User Man ual 93
To Next Page
Loading...
