c. Locate and then double click the setup file that you previously stored.
d. Verify that the instrument retrieved the saved setup. Do this by noticing
the horizontal SCALE is again 1 ms and the waveform shows ten cycles
just as it did when you saved the setup.
9. Remove the test hookup: Disconnect the test hookup from the instrument.
Performance verification (MSO/DPO70000C, MSO/DPO70000DX, and DPO7000C series)
112 MSO70000C/DX, DPO70000C/DX, DPO7000C, MSO5000/B, DPO5000/B Series
To Next Page
Loading...
