ppendix A: Specifications
This appendix conrains
complete spcciftcations for the TDS 340,
TDS 360, and
TDS 380. The specifications are divided into three subsections, one for each of
thm classes
of
traits: Warrutted
Characteristics, Typical
Churacteriscics, and
Nominal Trails.
Warranted Characteristics
Warranted characteristics are described in terms of quantifiable performance
limits that *are warranted. This subsection lists only warranted characterktics.
NOTE In these tables, those warranted characteristics that ore checked
in
the
Pcrformancc Tests,
starting on page B-5, appear in boldfnce type under lhe
column Name.
Performance Conclitions
The electrical characteristics found in these tables of warranted characteristics
apply when the oscilloscope has been adjusted at an ambient remperaturc
between +20” C and +30” C, has had a warn-up period of at least 20 minntcs,
and is operating at an ambient temperature bctwcen-10” C and +55’ C (unless
otherwise noted).
0 I ‘C
7
Table A-l: Warranted characteristics -signal acquisition system
Name
Accuracy, DC Voltage Measurement,
Average Acquisition Mode
Description
Measurement type
Average of 216 waveforms
1 DC accuracy
i(2.0% x I(reading - Net Ofketl)l + Offset
I
1 Accuracv + 0.1 div\
Delta volts between any two averages of
216 waveforms acquired under the same
*(2-O% x lreadingl + 0.15 div + 0.3 mV)
setup
and
ambient conditions
Accuracy, DC Gain, Sample or
Average Acquisition Modes
Pulse Response, Peak Detect and
Envelope Mode
2%
SeclDiv setting
5 sldiv - 25 wdiv
TDS 340: 10 psidiv
- 5 n&v
TOS 360: 10 ps/div - 2.5 ns/div
TDS 380: 10 psldiv - 1 nsldiv
I
TDS 340, TDS 360 & TDS 380 User Manual
Minimum pulse width
lone
The greater of 10 ns or
.OZ x se&iv setting
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
