Tektronix TDS 360 Technical Reference

TDS 340A, TDS 360 & TDS 380 Technical Reference
8–1
Electrical Parts List
This chapter contains a list of the replaceable parts for the TDS 340A, TDS 360,
and TDS 380. Use this list to identify and order replacement parts.
Parts Ordering Information
Replacement parts are available through your local Tektronix field office or
representative.
Changes to Tektronix products are sometimes made to accommodate improved
components as they become available and to give you the benefit of the latest
improvements. Therefore, when ordering parts, it is important to include the
following information in your order.
 Part number (see Part Number Revision Level below)
 Instrument type or model number
 Instrument serial number
 Instrument modification number, if applicable
If you order a part that has been replaced with a different or improved part, your
local Tektronix field office or representative will contact you concerning any
change in part number.
Change information, if any, is located at the rear of this manual.
Tektronix part numbers contain two digits that show the revision level of the
part. For some parts in this manual, you will find the letters XX in place of the
revision level number.
670-7918-03
Part Number Revision Level
670-7918-XX
Revision Level May Show as XX
When you order parts, Tektronix will provide you with the most current part for
your product type, serial number, and modification (if applicable). At the time of
your order, Tektronix will determine the part number revision level needed for
your product, based on the information you provide.
Part Number Revision
Level

Tektronix TDS 360 Specifications

General

Brand	Tektronix
Model	TDS 360
Category	Test Equipment
Language	English