Command Descriptions
2–60
TDS Family Oscilloscope Programmer Manual
%
#
%
or = 0 turns alias expansion off. If a defined alias is sent when
ALIas:STATE is OFF, a command error (102) will be generated.
or 0 turns alias expansion on. When a defined alias is received, the
specified command sequence is substituted for the alias and executed.
turns the command alias feature off.
returns when alias mode is off.
ALLEv? (Query Only)
Causes the digitizing oscilloscope to return all events and their messages, and
removes the returned events from the Event Queue. The messages are separated
by commas. Use the *ESR? query to enable the events to be returned. For a
complete discussion of the use of these registers, see page 3–1. This command is
similar to repeatedly sending *EVMsg? queries to the instrument.
Status and error
*CLS, DESE, *ESE, *ESR?, EVENT?, EVMsg?, EVQTY, *SRE, *STB?
'
'
The event code and message in the following format:
'!& "" &$!" '!& ""
&$!
&$! %%" !
Arguments
Examples
Group
Related Commands
Syntax
Returns
To Next Page
Loading...
Need help?
General
