Tektronix TDS 500C Programmer's Manual

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–85
CURSOR:MODE?
might return :TRACK showing the two cursors move in unison.
CURSor:PAIred
Positions the paired cursors. Also, returns the current paired cursor settings.
In extended-acquisition-length mode, the cursors are limited to the waveform
record section of the acquisition data (see Figure 2–4 on page 2–41).
Cursor
DATa:STARt, DATa:STOP
CURSor:PAIred SNAp
CURSor:PAIred?
CURSor
:
PAIred
?
<Space>
SNAp
SNAp positions the paired cursors at DATa:STARt and DATa:STOP.
CURSOR:PAIRED SNAP
specifies the positions of the cursors are at the current DATA:START and
DATA:STOP values.
CURSOR:PAIRED?
might return :CURSOR:PAIRED:UNITS BASE;POSITION1 -2.00E-3;POSITION2
2.00E-3;SELECT CURSOR2.
CURSor:PAIred:HDELTA (Query Only)
Queries the hbar (voltage) distance between the first and second paired cursor.
This is the absolute value of the vertical position of the first cursor minus the
vertical position of the second cursor.
Cursor
CURSor:FUNCtion
Group
Related Commands
Syntax
Arguments
Examples
Group
Related Commands

Tektronix TDS 500C Specifications

General

Brand	Tektronix
Model	TDS 500C
Category	Test Equipment
Language	English