Adjustment Procedures
Adjustment Procedures
5Ć16
H & # "#!$#" $! ( # !% # ! '
%!"
Use a small standard screw
driver to pry between the cover
and metal cord connector to pop
off cover.
Repeat for lower cover.
Figure 5Ć7:ăExposing the Probe Body
Hook up the test signal source:
Calibration
Generator
Tunnel Diode Pulser
10X AttenuatorPrecision Cable
$# $
#
Figure 5Ć8:ăInitial Test Hookup
H # # ( #$ $# $# # !# !#!
#!$ W !" # # $# #$
$"! " $! (
H # # $# $# # #$ $"! #!$
##$#! #
H # # #!! % # #$ $"! # $
Initialize the oscilloscope:
H !"" "%! SETUP
H !"" # ($ $## Recall Factory Setup
To Next Page
Loading...
