Command Descriptions
2–96
TDS Family Oscilloscope Programmer Manual
DELETE:SETUP ALL
removes all stored setups. All ten storage locations are initialized to the factory
default setup.
DELEte:WAVEform (No Query Form)
Deletes one or all of the stored reference waveforms from memory. The memory
allocated for the reference location is then available for reallocation. Memory
must be reallocated for the deleted references before any waveform data can be
stored in the reference location.
NOTE. The waveform data is not actually cleared from the reference location.
Save and Recall
RECAll:WAVEform, SAVe:WAVEform, TEKSecure
DELEte:WAVEform { REF<x> | ALL }
DELEte :
<Space>
ALL
<x>
WAVEform
REF
REF<x> (REF1, REF2, REF3 or REF4) specifies one of the reference memory
locations.
ALL specifies all the stored waveforms.
DELETE:WAVEFORM ALL
removes all the waveforms stored in reference memory.
DELETE:WAVEFORM REF2
removes the waveform stored at REF2.
DESE
Sets and queries the bits in the Device Event Status Enable Register (DESER).
The DESER is the mask that determines whether events are reported to the
Standard Event Status Register (SESR), and entered into the Event Queue. For a
more detailed discussion of the use of these registers, see page 3–1.
Examples
Group
Related Commands
Syntax
Arguments
Examples
To Next Page
Loading...
Need help?
General
