Tektronix TDS 600B

Table of Contents
TDS 500C, TDS 600B & TDS 700C Performance Verification and Specifications
iii
Figure 1–33: Subsequent 60 Hz Rejection test hookup 1–75. . . . . . . . . . . .
Figure 1–34: 60 Hz Rejection test result – TDS 684B shown 1–76. . . . . . .
Figure 1–35: Line count accuracy test hookup 1–77. . . . . . . . . . . . . . . . . . .
Figure 1–36: Line count accuracy test setup waveform –
TDS 684B shown 1–78. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 1–37: Line count accuracy correct result waveform 1–79. . . . . . . .
Figure 1–38: Setup for sync duty cycle test 1–81. . . . . . . . . . . . . . . . . . . . . .
Figure 1–39: Sync duty cycle test: one-div neg pulse waveform 1–82. . . . .
Figure 1–40: Sync duty cycle test: critically adjusted pulse 1–83. . . . . . . .
Figure 1–41: Sine wave generator leveling equipment setup 1–85. . . . . . .
Figure 1–42: Equipment setup for maximum amplitude 1–86. . . . . . . . . .
Figure 1–43: Reference-receiver performance-verification set up 1–89. . .
Figure 1–44: Optical impulse of Ch1 input from OA5022 Optical
Attenuator (OIG501 / OIG502 fed into optical attenuator
in Step 1) 1–91. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 1–45: Optical impulse response for OC–12 SONET
Reference Receiver 1–94. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 1–46: Optical impulse response for OC–12 SONET
Reference Receiver 1–95. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .