Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–215
SELect:<wfm>
Controls the display and selection of waveforms. There can be up to eleven
waveforms displayed at one time, but only one waveform can be selected at a
time. The selected waveform is the waveform that was most recently turned on.
This command is equivalent to pressing a front-panel CH or MORE button.
<wfm> can be CH<x>, MATH<x>, or REF<x>.
Vertical
or = 0 turns off the display of the specified waveform.
or 0 turns on the display of the specified waveform. The waveform
also becomes the selected waveform.
turns the channel 2 display on and selects channel 2.
returns either or , indicating whether the REF1 waveform is selected.
SELect:CONTROl
Sets or queries the waveform that is currently affected by the cursor and vertical
commands.
Vertical
Group
Syntax
Arguments
Examples
Group
Syntax
To Next Page
Loading...
