Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–223
selects AC trigger coupling (not on TDS 684A & 7XXA).
selects DC trigger coupling.
coupling removes the high frequency components of the DC signal
(not on the TDS 684A & 7XXA).
coupling removes the low frequency components of the AC signal
(not on the TDS 684A & 7XXA).
coupling sets the delayed trigger coupling to match the setting on
the main trigger (TDS 684A & 7XXA only).
selects DC low sensitivity.
sets the delay trigger to DC coupling.
might return for the delayed trigger coupling.
TRIGger:DELay:EDGE:SLOpe
Selects either a rising or falling edge for the delayed trigger. This command is
equivalent to selecting Slope in the Delayed Trig menu.
Trigger
! " # $
!
!
specifies to trigger on the falling or negative edge of a signal.
specifies to trigger on the rising or positive edge of a signal.
Arguments
Examples
Group
Syntax
Arguments
To Next Page
Loading...
Need help?
General
