Preface
xii
TDS 500D, TDS 600B, & TDS 700D User Manual
Default Model
This manual documents the TDS 500D, TDS 600B, & TDS 700D Digitizing
Oscilloscopes. Take special note of the following conventions:
Some TDS models have two auxiliary channels called AUX 1 and AUX 2,
instead of CH 3 and CH 4. References to these channels default to CH 3 and
CH 4; if your oscilloscope is one of these models, read AUX 1 and AUX 2
respectively for all references to CH 3 and CH 4 in this manual.
The TDS 684B display screen appears as the default screen wherever a
display screen is illustrated in this manual.
Model References
This manual documents the TDS 500D, TDS 600B, & TDS 700D Digitizing
Oscilloscopes. Take note of the following conventions used when referencing
these oscilloscopes:
The name “TDS 500D” is used when providing information common to the
TDS 520D, TDS 540D, and TDS 580D model oscilloscopes.
The name “TDS 600B” is used when providing information common to the
TDS 620B, TDS 644B, TDS 680B, and TDS 684B model oscilloscopes.
The name “TDS 700D” is used when providing information common to the
TDS 724D, TDS 754D, TDS 784D, and TDS 794D model oscilloscopes.
Conventions
In this manual, you will find various procedures which contain steps of
instructions for you to perform. To keep those instructions clear and consistent,
this manual uses the following conventions:
In procedures, names of front panel controls and menu labels appear in
boldface print.
To Next Page
Loading...
Need help?
General
