Command Descriptions
2−106
TDS200/1000/2000 Series Oscilloscope Programmer Manual
Definition for the math waveform.
MATH?
returns :MATH:DEFINE CH1 + CH2" if the math waveform is
defined as channel 1 plus channel 2.
MATH:DEFINE
Performs the specified mathematical operation on the input signal or
signals. To activate or deactivate the math waveform, use the
SELect:<wfm> command (refer to page 2-134).
Vertical
MATH:DEFINE <QString>
MATH:DEFINE?
NOTE. Remember that <QString> must be enclosed in quotes. You
can use white space characters between words.
<QString> specifies a math waveform, and can be one of the
following:
TDS1002, TDS1012, TDS2002, TDS2012 and TDS2022 models; TDS210 and
TDS220 models (firmware V2.00 and above) with a TDS2MM measurement
module.
CH1+CH2
CH1–CH2
CH2–CH1
FFT (CH<x> [, <window>])
Returns
Examples
Group
Syntax
Arguments
To Next Page
Loading...
