Tektronix TDS200 Series - Page 125

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−107
TDS2014 and TDS2024 models; TDS224 model with a TDS2MM measure−
ment module.
CH1+CH2
CH3+CH4
CH1–CH2
CH2–CH1
CH3–CH4
CH4–CH3
FFT (CH<x> [, <window>])
TDS210 and TDS220 models, firmware below V2.00 with a TDS2CMA
communications module.
CH1–CH2
CH2–CH1
CH1+CH2
–CH1
–CH2
TDS210 and TDS220 models (firmware below V2.00) with a TDS2MM
measurement module.
CH1+CH2
(to subtract, invert one of the waveforms through CH<x>:INVert,
and then add)
FFT (CH<x> [, <window>])
TDS210 and TDS220 models (firmware V2.00) and above with a TDS2CMA
communications module.
CH1+CH2
CH1–CH2
CH2–CH1
TDS224 model with a TDS2CMA communications module.
CH1+CH2
CH3+CH4
CH1–CH2
CH2–CH1
CH3–CH4
CH4–CH3