Command Descriptions
2−120
TDS200/1000/2000 Series Oscilloscope Programmer Manual
MEASUrement:MEAS3:UNIts?
might return V", indicating the units for measurement 3 are volts.
MEASUrement:MEAS<x>:VALue? (Query Only)
Returns the value that has been calculated for the oscilloscope
on-screen periodic measurement specified by <x>.
This value is a display value and will be updated about every 1/2
second if both the MEASURE menu and the MEAS<x> source
channel are displayed. If you are acquiring at a slow sweep rate, the
oscilloscope may take longer than 1/2 second to update. MEASure-
ment:IMMed is usually more useful than MEASUrement:MEAS<x>
when using the oscilloscope with external devices.
If MEASUrement:MEAS<x>:TYPe is set to NONE, MEASUre-
ment:MEAS<x>:VALue? generates event message 2231 (Measure-
ment error, measurement is not activated) and returns 9.9E37.
If the channel specified by MEASUrement:MEAS<x>:SOUrce is not
displayed on the oscilloscope, the oscilloscope generates event
message 2225 (Measurement error, no waveform to measure) and
returns 9.9E37.
NOTE. If Trigger View is active, scan mode is in effect, or the display
format set to XY, this query generates event 221 (Settings conflict)
and returns 9.9E37.
Measurement
MEASUrement:MEAS<x>:VALue?
<NR3>
Examples
Group
Syntax
Returns
To Next Page
Loading...
