Command Descriptions
2−82
TDS200/1000/2000 Series Oscilloscope Programmer Manual
Refer to the service manual for your oscilloscope for information
about error log message format.
ERRLOG:NEXT? (Query Only)
Returns the next entry in the error log, or an empty string if the error
log is empty or you have reached the end of the log. To start at the
top of the error log, run the ERRLOG:FIRST? query to return the
first error log message. Then use the ERRLOG:NEXT? query to step
through the error log.
Calibration and Diagnostic
ERRLOG:NEXT?
Refer to the service manual for your oscilloscope for information
about error log message format.
*ESE
Sets and queries the bits in the Event Status Enable Register (ESER).
The ESER prevents events from being reported to the Status Byte
Register (STB). Refer to the Status and Events chapter on page 3-1
for more information.
Status and Error
*ESE <NR1>
*ESE?
Returns
Group
Syntax
Returns
Group
Syntax
To Next Page
Loading...
