Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−75
*TRG
DESE
Sets and queries the bits in the Device Event Status Enable Register
(DESER). The DESER is the mask that determines whether or not
events are reported to the Standard Event Status Register (SESR),
and entered into the Event Queue. Refer to the Status and Events
chapter on page 3-1 for more information.
Status and Error
DESE <NR1>
DESE?
<NR1> is an integer value in the range from 0 to 255. The binary bits
of DESER are set according to this value. For example, DESE 209
sets the DESER to the binary value 11010001 (that is, the most
significant bit in the register is set to 1, the next most significant bit
to 1, the next bit to 0, and so on).
The power-on default for DESER is all bits set to 1 if *PSC is 1. If
*PSC is 0, the DESER maintains its value through a power cycle.
NOTE. Setting DESER and ESER to the same value allows only those
codes to be entered into the Event Queue and summarized on the
ESB bit (bit 5) of the Status Byte Register. Use the *ESE command to
set ESER. For more information on event handling, refer to the
Status and Events chapter.
Related Commands
Group
Syntax
Arguments
To Next Page
Loading...
