Tektronix TDS7054

Table of Contents
TDS7104 & TDS7054 Service Manual
v
List of Figures
Figure 2--1: Locations of peripheral connectors on rear panel 2--3.....
Figure 2--2: Line fuse and power cord connector locations,
rear panel 2--4.............................................
Figure 2 --3: On/Standby switch location 2--5.......................
Figure 4 --1: Toolbar and menu bar 4--3...........................
Figure 4--2: Universal test hookup for functional
tests -- CH 1 shown 4--7.....................................
Figure 4 --3: Channel button location 4--8..........................
Figure 4--4: Setup for time base test 4--10...........................
Figure 4--5: Setup for trigger test 4--12.............................
Figure 4--6: Setup for the file system test 4--14.......................
Figure 4--7: Initial setup 4--20....................................
Figure 4--8: Setup to characterize signal source outputs 4--23..........
Figure 4--9: Setup to check delay between channels 4--24..............
Figure 4--10: Setup to check delta time accuracy 4--24................
Figure 4 --11: Setup to check probe compensation output 4--25.........
Figure 4--12: Setup to check analog signal output 4--25...............
Figure 4--13: Setup to check auxiliary output 4--25...................
Figure 4--14: Initial test hookup 4--36..............................
Figure 4--15: Measurement of DC accuracy at maximum
offset and position 4--38......................................
Figure 4--16: Initial test hookup 4--39..............................
Figure 4--17: Measurement of DC gain accuracy 4--42................
Figure 4--18: Initial test hookup 4--44..............................
Figure 4--19: Optional initial test hookup 4--44......................
Figure 4--20: Measurement of analog bandwidth 4--47................
Figure 4--21: Initial test hookup 4--49..............................
Figure 4--22: Measurement of channel delay 4--51...................
Figure 4--23: Initial test hookup 4--53..............................
Figure 4--24: Initial test hookup 4--57..............................
Figure 4--25: Measurement of accuracy -- long-term and
delay time 4--59.............................................
Figure 4--26: Initial test hookup for external reference 4--60...........
Figure 4 --27: Final test hookup for external reference input 4--61.......
Figure 4--28: Delta time accuracy test hookup 4--62..................