Chapter 3 Configuration
You can connect to a 4G network through the Teldat 4Ge using a device from Teldat, Cisco or from a different man-
ufacturer. The following sections show to configure the router in all cases.
3.1 Configuring a Cisco router
Connecting a Cisco router to a WWAN mobile network through a Teldat 4Ge with VLAN 463 is carried out through
an Ethernet subinterface.
The following example can be used as a guideline on how to connect a Cisco router through the Teldat 4Ge:
Current configuration : 1634 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
logging message-counter syslog
enable secret 5 $1$Shh8$vJXxVHzI4oGPou3hFCq7E0
enable password cisco
!
no aaa new-model
!
!
dot11 syslog
ip source-route
!
!
ip dhcp pool 4Ge
host 2.2.2.2 255.255.255.0
client-identifier 7465.6c64.6174
option 43 ascii
“antenna&apn=internet.es&pin=1844&ntps=192.168.212.14&usr=internet&pwd=internet"
default-router 2.2.2.1
!
!
ip cef
no ipv6 cef
!
multilink bundle-name authenticated
!
!
archive
log config
hidekeys
!
!
interface FastEthernet0/0
ip address 192.168.212.133 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
ip address 2.2.2.1 255.255.255.0
ip nat inside
Teldat S.A.
3 Configuration
Teldat 4Ge 7
To Next Page
Loading...
Need help?
General
