What to do if LED 1, 2, 3, or 4 (WWAN modules) remains OFF on Teldat H2 RAIL Network Router?
If LED 1, 2, 3, or 4 (WWAN modules) remains OFF on your Teldat Network Router, check if the SIM card has been inserted correctly. Also, verify that you have entered the correct SIM PIN. Ensure the antenna is properly installed and screwed in correctly. Finally, check that the SIM tray configuration is correct.
How to troubleshoot Teldat Network Router when none of the LEDs light up?
If none of the LEDs on your Teldat Network Router light up, check the power supply to the router, including the power supply cable and the main power outlet.
General| Category | Network Router |
|---|---|
| Model | H2 RAIL |
| Operating Temperature | -40°C to +70°C |
| Cellular | 4G LTE |
| Wi-Fi | Yes |
| GPS | Yes |
| Device Type | Industrial Router |
| Ethernet Ports | 4 |
| WAN Ports | Ethernet |
| Wi-Fi Standards | 802.11 a/b/g/n |
| Certifications | EN 50155, EN 45545 |
| Connectivity | Ethernet, Cellular, Wi-Fi |
| Form Factor | Rail-mounted |
Defines supported devices, contents, exclusions, organization, and technical support.
Details the device's function, railway compliance, certifications, and references to power/monitoring.
Covers front/rear panels, connectors (LAN, AUX, WWAN, WLAN, GPS), LEDs, and SIM trays.
Covers mounting, power connection, reset functions, and SIM card installation.
Covers manufacturer info, risk/safety warnings, WEEE, REACH, EC declaration, national restrictions.
Covers handling, ESD, SIM voltage, environmental specs, and labeling symbols.
Addresses common problems, solutions, maintenance, and software update procedures.
Details connector, interface, hardware architecture, power, and housing specifications.
Provides detailed specifications for WWAN, WLAN, and GPS interfaces including data rates and frequencies.
Lists RF WAN frequency bands, power, and WLAN specs like frequency, modulation, and output power.
To Next Page
