4.6 EC declaration of conformity
English (EN) Hereby, Teldat S.A. declares the radio equipment type Teldat H2 RAIL is in com-
pliance with:
Directive 2014/53/EU (RED)
Directive 2011/65/EU (RoHS)
as given by the European Parliament.
Spanish (ES) Español Por la presente, Teldat S.A. declara que el tipo de equipo radioeléctrico Teldat H2
RAIL es conforme con:
Directiva 2014/53/UE (RED)
Directiva 2011/65/CE (RoHS)
del Parlamento Europeo.
German (DE) Deutsch Hiermit erklärt Teldat S.A., dass der Funkanlagentyp Teldat H2 RAIL der Richt-
linie:
Richtlinie 2014/53/EU (RED)
Richtlinie 2011/65/EU (RoHS)
des Europäischen Parlaments.
The EC declaration of conformity can be found at http://www.teldat.com/conformity.
In addition to this conformity, Harmonized Standards have been applied to the TLDPH00H1.A hardware and CIT
11.01 software version, in order to meet the essential requirements of the Directives.
4.7 National restrictions
In accordance with Article 10 of 2014/53/EU, we inform you that national restrictions and requirements may apply
when it comes to authorization. Not all EU countries have implemented the harmonized use of 5 GHz for the imple-
mentation of WAS/RLANs. There are restrictions in:
Albania, Andorra, Azerbaijan, Moldova, Monaco, San Marino and Vatican City
The requirements for any country may evolve. Teldat S.A. recommends that you check with local authorities for any
requirements or restrictions that may apply.
This product is supplied without antennas. Choosing antennas is at the discretion of the operator, but said party is re-
sponsible for ensuring they comply with local regulations.
Make sure the characteristics of the antennas used match the regulations applicable in the installation location.
4.8 Operating frequency
4.8.1 WWAN antenna
This device is to be used only for mobile and fixed applications; and must not be co-located or operating in conjunc-
tion with any other antenna or transmitter. For mobile and fixed operating configurations the WWAN antenna gain, in-
cluding cable loss, must not exceed 6 dBi at 700, 850, 1700 and 1900 MHz, 9 dBi at 2500/2600 MHz, and 1 dBi at
2300 MHz. This is to meet RF exposure compliance requirements. Under no conditions may an antenna gain be
used that would exceed the ERP and EIRP power limits as specified in the EN 301 908-x standard.
Teldat S.A.
4 Compliance
Teldat H2 RAIL 19
To Next Page
Loading...
Need help?
General
