The client-id option indicates the “client-id ” that the router is expecting to receive in the DHCP request from the
Teldat 4Ge. This value must be the “antenna” characteristics.
Through option 43, the Teldat 4Ge receives the essential parameters for the configuration so it can operate. The
syntax and meaning is the same as that described under section DHCP on page 8 in the section Configuring a Cisco
router on page 7.
The first word contained in option 43 should be “antenna”. Since the device accepts the address offered by the
router, if you don’t enter this word the Teldat 4Ge won’t accept said address.
3 Configuration Teldat S.A.
12 Teldat 4Ge
To Next Page
Need help?
General
