90453-02 Rev A0 Introduction 1-5
Figure 1-6 shows a typical NetBlazer 40i rear panel. The power switch is
located near the fan above the power connector.
Figure 1-6. NetBlazer 40i — Typical Rear Panel
The console port is an RS-232 serial port for use with an asynchronous
terminal operating at 9600 baud (do not use the console port as a modem
port). To the right of the console port are the chassis I/O ports. The Net-
Blazer 40i includes12 megabytes of system memory.
Hardware Configuration
You can install up to three option boards in the NetBlazer STi, and up to six
option boards in the NetBlazer 40i.
Table 1-1 provides a list of available options. Contact your distributor or
reseller for up-to-date ordering information on NetBlazer options.
NetBlazer
®
NetBlazer Combo Board
line00
line01
line02
(console)
Book Page 5 Thursday, March 27, 1997 10:55 AM
To Next Page
Loading...