LED Malfunction Alert
A. TX red LED is flashing quickly when any function pushbutton is
pressed, then the problem could be:
(a) One of the pushbutton is jammed.
(b) The EMS mushroom has not been released.
(c) The system is not properly powered on according to the
instructions. If a problem on the above is found, please contact
the distributor for repair.
B. TX LED will flash slowly if the memory of the transmitter is
defective. Please contact the distributor for repair.
C. RX Error LED will flash slowly if the memory of the receiver is
defective. Please contact the distributor for repair.
6
Troubleshooting
A. If TX LED remains with “ON” in red , please remove the batteries
and insert again.
B. If the RX does not respond at all, please turn off the power supply
for 20 seconds and then turn it on again to the receiver.
To Next Page
Loading...
Need help?
General
