conducted within a certain time, in order to operate
with short and precision movement.
d. “EMS(STOP): This function is only selected by F21-2S/2D. If
set “EMS(STOP), the “Power On Mode” must be
set as “Any Pushbutton”; if not, the magnetic
key substitutes for the function of “EMS(STOP)”.
1-24. “ID RemoteSet”: “Enable” or “Disable”.
a. “Enable”: ID Code Remote setting allows you to overwrite only
ID code of Receiver when Receiver or Transmitter is
damaged. Before remote setting, one must make sure
both TX and RX are in same frequency channel. By
using remote setting, Receiver ID Code will be
overwriting by the Transmitter.
Note:
(1) All radios of same model within its radio operating distance,
might be affected by ID code remote setting.
(2) Transmitter ID code remote setting overwrite the ID code of
receiver only.
(3) Receiver will not accept ID code remote setting signal 4
minutes after main power being turned ON.
b. “Disable”: ID Code Remote setting is not available. So it is
required to use Copier or PC/Laptop to read and write
the same ID code and functions to the Transmitter or
Receiver.
1-25. “Power On Mode”: “Any Pushbutton” or “Start pushbutton/Key”.
a. “Any Pushbutton”: Pull out EMS button (mushroom) and remain
Rotary key switch in “on” position (for F21-
2S/2D/4SB/E1B, release EMS(STOP) button
and insert Magnetic key in its slot in the
Transmitter), the receiver will be “Power On”
once any pushbutton on transmitter is pressed.
17
To Next Page
Loading...
